elpis
Junior Member
Posts: 11
|
Post by elpis on Sept 5, 2005 11:04:41 GMT 1
could someone tell me how can i flash on the dispay of my comcrypt the indication "E0"
|
|
|
Post by JTH on Sept 6, 2005 7:00:55 GMT 1
yes... well... its not easy but it can be done... 1. get the datasheet of the display. -to get it, enter in google: "<display type> display datasheet" (for example give: "XC321B display datasheet"). 2. write down the pins that control the according leds that format 'E0' -there are nine leds total. 3. cut all the traces from all the pins except from the common pin (consult the datasheet to find it) 4. connect nine 680Ù resistors from the pins that control E0 to the ground... Now your display says: E0 !!!!! ;D
|
|
|
Post by JTH on Sept 6, 2005 7:06:11 GMT 1
|
|