Post by LeonM on Jan 31, 2004 22:01:05 GMT 1
Hi there,
I just obtained a old cablecrypt box, and i'm trying to get is to work with canal+ (in holland)
I've done the mod as discribed here* but that didn't work, the signal is still the same as before.
Then I found this:
So I had to use a 1K resistor, but the box still does not work. The screen keeps flashing with the EO text.
Iv'e checked the whole thing over and over, and I'm sure I did everything right as discribed in the manual.
What else can I try?
* golftouch.nl server doesn't seem to like deeplinks, but you know what page I mean
I just obtained a old cablecrypt box, and i'm trying to get is to work with canal+ (in holland)
I've done the mod as discribed here* but that didn't work, the signal is still the same as before.
Then I found this:
Count the voltage level on the trimmer pin witch is alone (not the ones that are connected together). It must be –2.5 to –3Volts. If its not, adjust the trimmer and if this wont do, connect from this pin to the ground a 1K resistor and readjust so the voltage level goes between –2.5 to –3Volts and the circuit works.
So I had to use a 1K resistor, but the box still does not work. The screen keeps flashing with the EO text.
Iv'e checked the whole thing over and over, and I'm sure I did everything right as discribed in the manual.
What else can I try?
* golftouch.nl server doesn't seem to like deeplinks, but you know what page I mean
